Daytona Classic Army G36 HPA Recoil Conversion Kit

Daytona Airsoft
Conversion Kits

Designed for the CA G36C/E/K

The Daytona Airsoft G36 kit converts your AEG CA G36 to a HPA-powered recoil system that allows you to use AEG G36 mags. No more green gas or propane cooldown. 


Components Material:

Machined Steel, brass and 6061 aluminum

70 Dura synthetic rubber

Bolt Carrier Material:

Steel bolt with brass bolt tank

Power  Adjustment Range:

1.3J ~ 2J

Operating Pressure:

80 ~ 155 PSI

Rate of Fire:

750 ~ 950 Rounds per Minute

Range test:

Stress Test:

The Daytona Airsoft System kit means you can have even more recoil, louder noise than GBB system, and increased effective range like fusion engine, without spending a fortune on GBBR mags. It requires around 2000-4000 bb break-in period where a small number of fliers and chopping of bbs may occur. This is normal while the system is breaking in.

You are required to install an AEG barrel made of either brass or steel. Never use aluminum barrel since it will be bent by hop up set screws. You also need to prepare an HPA tank and Redline regulator with single QD disconnector wide bore airline

During the break-in period, please keep lubing your gun with getsome 1000 lubricant. Only use the quality BBs that you intend to use for gaming during break-in, never cheap out.  As soon as all your shots are consistent you can turn on the hop-up gradually (1/8 turn each time) until you reach your designated trajectory.


The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.
Daytona Classic Army G36 HPA Recoil Conversion Kit
You have successfully subscribed!
This email has been registered
Recently Viewed